What should the outside surface of a firearm be cleaned with

Worn areas require light lubrication. During this process, you want to carefully inspect each piece as you put it together and make a note of any damage, irregularities, or excessive wear or play movement. Occasional dents or scratches happen. Other damage not only hurts the value of your firearm but can lead to potential safety concerns. Should you find anything questionable in your inspection, we highly recommend you take it to a local firearms shop or competent gunsmith.

For long term storage of firearms, you can use this step to apply preservative oils and then utilize a storage system.

Remember to wipe down your hands and work surfaces after firearm cleaning with a cleaning cloth to remove lead and other heavy metal residues. Completely Unload the Handgun This is the most crucial step in the entire cleaning process.

A firearm holder also called a gun rest to hold the firearm firmly in a horizontal position. Gunsmithing screwdrivers to ensure that your firearm comes apart and goes back together smoothly. A short copper cleaning brush or an old toothbrush to clean out hard-to-reach areas. Bore light or light pipe to inspect bores, chambers, and other hard-to-see areas.

Eye-protection gear to protect your eyes from springs, tensioned parts, and cleaning solvents. Gun cleaning solvents, oil and grease to clean and protect your firearm. Six steps to clean a firearm Step 1. Place an unloaded firearm in a bench rest and secure it so it will not fall.

Attach a cleaning brush that is the same size as the caliber or gauge of your firearm onto a cleaning rod. Pour a small amount of cleaning solution into an open container, such as a film canister, and dip the brush into the cleaning solution. Step 2. Place the cleaning rod with brush attached into the bore and work the brush down the entire length of the barrel. Step 3. Bit like Rem-Oil. I would never consider putting WD near any of my firearms, my choice only. I wipe the whole firearm, metal and wood.

Don't live on the coast and firearms are stored inside with moisture control inside the gun safe. DIY wax or Birchwood Casey wax on wood. Will also work on metal as rust inhibitor. Treat trolls with the contempt they deserve. I then use a RIG Rag.

That of course is on the metal, for the wood, it is furniture polish and or linseed oil. I've been asked: "How many guns do you need to have? I wouldnt put it on my gun either. I just wipe with very lightly oiled cloth. Use only tools and chemicals designed for the purpose of maintaining firearms. Use care when working with solvents to prevent drippage onto wood, painted or other sensitive surfaces.

Dry brush the chamber and barrel with a copper-phosphate or nylon bore brush in a chamber to muzzle direction. This will loosen and remove some of the large carbon and metal fouling from the bore. Place a cleaning patch dipped in bore solvent on the tip of your cleaning rod. Next, push the cleaning patch through the barrel and out the other side and saturate the chamber and bore surface. Next, use just the bore brush to scrub the inside of the barrel.

Use a new, dry patch to remove any residue and keep running it through the bore until the patch comes out clean. Use a pull-through tool impregnated with a light lubricant, such as a bore snake and CLP or equivalent to further clean and treat the bore surface against corrosion. Do not lubricate the bore using gun oil! For long term storage only, the bore can be treated with a heavier lubricant such as Barricade or equivalent. This must be removed by cleaning the barrel prior to shooting the firearm!

You need to clean and lubricate more than just the barrel of the gun. The action slide, pump, or bolt should also be cleaned using a nylon utility brush, dry cloth, and action cleaner solvent. Allow the cleaned sub-assemblies to dry. Use proper disposal procedures for any cleaning residues.

It is important not to over lubricate, as this will more readily attract contaminant accumulation and could potentially cause reliability issues. Magazines are the source of ammunition and are responsible for proper feeding of a semiautomatic firearm. Reliable, clean magazines are critical for the proper operation of a semiautomatic.